mosriteforum.com

I've had one of these Fullerton MoVibe HH for years and decided to finally fix it up. The previous owner had butchered the Pickguard (actually the entire darn guitar if I may say so) so I'm on the hunt for a replacement. It looks like it's measuring around 12" from top to bottom. I did find the STL files for this, but my bed on my 3d Printer isn't large enough, and I haven't used a slicer before with something like this.

Are there any budget friendly pickguard places for clones these days?

Here is a link to a green version of the guitar, I have the Metallic red version.
https://reverb.com/item/15328008-fuller ... srite-copy

Roncore wrote:I've had one of these Fullerton MoVibe HH for years and decided to finally fix it up. The previous owner had butchered the Pickguard (actually the entire darn guitar if I may say so) so I'm on the hunt for a replacement. It looks like it's measuring around 12" from top to bottom. I did find the STL files for this, but my bed on my 3d Printer isn't large enough, and I haven't used a slicer before with something like this.

Are there any budget friendly pickguard places for clones these days?

Here is a link to a green version of the guitar, I have the Metallic red version.
https://reverb.com/item/15328008-fuller ... srite-copy

Judging by the photo, it looks like the pickguard is very similar (if not nearly 1:1) the same as a Mosrite Ventures Mark V Pickguard. However, those aren't available just anywhere. I guess you might be able to buy one from Bob Shade at Hallmark Guitars, he might make one for you - however, I'm not sure that it would fit your Fullerton.

http://www.hallmarkguitars.com

I can suggest to print the pickguard on paper, then make a pickguard out of a blank with the pickguard being cut out of the paper. That's about all I can imagine now since I don't have a 3D Printer. You may need to take the file to a Staples and then have them print it 1:1 with the actual size of the pickguard.

- Austin